| Sun | Mon | Tue | Wed | Thu | Fri | Sat |
|---|---|---|---|---|---|---|
| 1 | 2 | |||||
| 3 | 4 | 5 | 6 | 7 | 8 | 9 |
| 10 | 11 | 12 | 13 | 14 | 15 | 16 |
| 17 | 18 | 19 | 20 | 21 | 22 | 23 |
| 24 | 25 | 26 | 27 | 28 | 29 | 30 |
« Betcha Didn't Know... | Main | Switching Decimal and Digit Grouping Symbols for HydraCALC »
And another thing...
Even been filling out an Info Sheet in HydraCALC and get to the part where it is asking for Flow Required and Pressure Required? Wish there was a quicker way to fill those in?
There is!
When at that page in the Info Sheet, pick the View pulldown and pick Calc Summary. This will open up the Calc Summary in Notepad.
You can then highlight the Flow and copy and paste it to the proper field in the info sheet. Do the same with the Pressure, too.
As a final step before posting your comment, enter the letters and numbers you see in the image below. This prevents automated programs from posting comments.
Having trouble reading this image? View an alternate.
Comments are moderated, and will not appear until the author has approved them.
Your Information
(Name is required. Email address will not be displayed with the comment.)
I know it's possible to have these fields filled in automatically for the 'TEST' node but, is it possible to pick where the info is taken (BOR, pump discharge, street, etc.). you may need to calc out to the street, but you may want/need another reading also.
thanks,
ed
aero automatic
Posted by: ed t | October 06, 2006 at 08:40 AM
Ed - I would LOVE to have these filled in automatically based on whatever node point you enter into the info sheet.
But I'm not the one that programs that... :)
Posted by: Art | October 06, 2006 at 10:13 AM