Listing a Plug at the top of a Tee in HydraCAD

From a customer: Can I AutoList a plug at top of this tee?

From my co-worker Bill - yes you can:

This will list the correct tee at the end of the riser nipple and will list the plug with the miscellaneous material.

1. Insert a sprinkler head block defined as “directly connected” at the riser nipple

2. We often use Head5 for this purpose because of how it looks

3a. Define the PLUG/sprinkler as “point down” and “at bottom” if the plug is at the bottom of the riser nipple. Note: use at Bottom - if the 1’-6” long pipe is lower than the 2’-3 ½” pipe in our example

3b. Select Choose 3D Head Block and select Plug1 as the 3D representation

4. Scale the plug/sprinkler block down a bit so you can tell it is there, but not so large as a sprinkler block